Paper contribution

Thermal Cycling Effects on Granite Pore Structure at Moderate Temperatures

María Elvira Garrido; Carlos Valentin Cedeño; Víctor Martínez-Ibáñez; Carlos Hidalgo-Signes; Diego José Guerrero-Miguel

Proceedings
EUROCK 2026
Pages
523-528
Submitted
28 January 2026
Accepted
15 June 2026
Published
12 August 2026

Summary

Abstract

Thermally induced microfracturing has emerged as an effective method to enhance permeability of low-porosity crystalline rocks in Enhanced Geothermal Systems (EGS). Most existing studies focus on high-temperature treatments (>500 °C), which limits their applicability under field conditions, where moderate temperatures and controlled thermal shocks are preferred. This study examines the evolution of porosity and pore structure in granite subjected to repeated heating-cooling cycles at relatively low temperatures to assess the feasibility of inducing microfracture development in geothermal reservoir stimulation. Granite samples were heated to 200, 300, and 400 °C and then cooled by immersion in water to generate a steep thermal gradient. Different groups of samples were exposed to 1 to 5 thermal cycles. Total and open porosity, density, and ultrasonic wave velocity were determined to assess progressive thermal damage. In addition, mercury intrusion porosimetry was performed to characterize variations in pore volume, pore size distribution, and pore connectivity. X-ray diffraction (XRD) analysis was conducted to detect potential mineralogical changes resulting from repeated thermal exposure. The results show a progressive decrease in bulk density and ultrasonic velocities with increasing temperature and cycle count, indicating the accumulation of microstructural damage. Open porosity shows a significant increase, particularly at 300 and 400 °C, while total porosity shows more limited changes, suggesting that increasing the cycle count improves pore connectivity. The porosimetry results confirm a shift toward larger pore sizes and improved connectivity after five cycles, especially at higher temperatures, reflecting microcrack coalescence. XRD analyses show no peak displacements or new mineral phases, confirming that the observed changes are not associated with mineralogical transformations. Overall, this study demonstrates that thermal treatment at moderate temperatures effectively improves porosity and microfracture connectivity in these rocks, offering a practical and energy-efficient method for geothermal reservoir stimulation.

Contributors

Authors

  1. María Elvira Garrido Universitat Politècnica de València, Spain ORCID 0000-0001-7804-3922
  2. Carlos Valentin Cedeño Universitat Politècnica de València, Spain
  3. Víctor Martínez-Ibáñez Universitat Politècnica de València, Spain
  4. Carlos Hidalgo-Signes Universitat Politècnica de València, Spain
  5. Diego José Guerrero-Miguel Universidad de Oviedo, Spain ORCID 0000-0002-9125-4860

Index terms

Keywords

Full text

Attachments

Works cited

References

  1. Gautam, P. K., Dwivedi, R., Kumar, A., Kumar, A., Verma, A. K., Singh, K. H., & Singh, T. N. (2020). Damage Characteristics of Jalore Granitic Rocks After Thermal Cycling Effect for Nuclear Waste Repository. Rock Mechanics and Rock Engineering, (0123456789). https://doi.org/10.1007/s00603-020-02260-7
  2. Gómez-Heras, M., Smith, B. J., & Fort, R. (2008). Influence of surface heterogeneities of building granite on its thermal response and its potential for the generation of thermoclasty. Environmental Geology, 56(3–4), 547–560. https://doi.org/10.1007/s00254-008-1356-3
  3. Griffiths, L., Heap, M. J., Baud, P., &Schmittbuhl, J. (2017). Quantification of microcrack characteristics and implications for stiffness and strength of granite. International Journal of Rock Mechanics and Mining Sciences, 100, 138–150. https://doi.org/10.1016/J.IJRMMS.2017.10.013
  4. Junique, T., Vazquez, P., Benavente, D., Thomachot-Schneider, C., &Géraud, Y. (2021). Experimental investigation of the effect of quenching cycles on the physico-chemical properties of granites. Geothermics, 97. https://doi.org/10.1016/j.geothermics.2021.102235
  5. Qin, Y., Tian, H., Xu, N. X., & Chen, Y. (2020). Physical and Mechanical Properties of Granite After High-Temperature Treatment. Rock Mechanics and Rock Engineering, 53(1), 305–322. https://doi.org/10.1007/s00603-019-01919-0
  6. Rong, G., Sha, S., Li, B., Chen, Z., & Zhang, Z. (2021). Experimental Investigation on Physical and Mechanical Properties of Granite Subjected to Cyclic Heating and Liquid Nitrogen Cooling. Rock Mechanics and Rock Engineering, 54(5), 2383–2403. https://doi.org/10.1007/s00603-021-02390-6
  7. Tomás, R., Benavente, D., Martínez-Ibáñez, V., & Garrido, M. E. (2025). How do high temperatures affect rock properties? A comprehensive review of experimental thermal effects and underlying mechanisms. In Engineering Geology (Vol. 357). Elsevier B.V. https://doi.org/10.1016/j.enggeo.2025.108323
  8. Yin, Q., Wu, J., Zhu, C., Wang, Q., Zhang, Q., Jing, H., &Xie, J. (2021). The role of multiple heating and water cooling cycles on physical and mechanical responses of granite rocks. Geomechanics and Geophysics for Geo-Energy and Geo-Resources, 7(3). https://doi.org/10.1007/s40948-021-00267-0
  9. Yu, L., Peng, H. W., Zhang, Y., & Li, G. wei. (2021). Mechanical test of granite with multiple water–thermal cycles. Geothermal Energy, 9(1). https://doi.org/10.1186/s40517-021-00186-z
  10. Zhu, Z., Tian, H., Mei, G., Jiang, G., & Dou, B. (2020). Experimental investigation on physical and mechanical properties of thermal cycling granite by water cooling. Acta Geotechnica, 15(7), 1881–1893. https://doi.org/10.1007/s11440-019-00898-4